EA8ARX, Amateur Radio, Hardware & Software

With a pair of 2.54 mm in-line male/female connectors and a piece of printed circuit board for prototypes, you can easily made an extension for mcHF V06 boards. I used a 40-pin connector and carefully cut the remaining 10 pins. In this way you can have an mcHF running at the same time that you can access both sides of each board. To avoid accidents, when mounting the mcHF, the female connector must be installed on the mchf_rf board. The reason is that this board supplies the supply voltages to the mchf_ui board. A male connector with power supply pins is always a potential risk. TRIC: It is possible to take +8 V (track 28), +5 V (track 27) and +3.3 V (track 26) in the connector/extension, as well as the connections to ground to use measuring instruments. You can also proceed in reverse way and apply power to mcHF_ui board by injecting the +5 volts into pin 28 of the connector, in this way you can update the firmware ( I use the bootloader 4.0 of df8oe) wit...

See also related post. mcHF V06 TX-RX relay antenna switching as implemented by Wolfram PY2BND This is the modification that I just made in my mcHF V06, inspired in df8oe RF-04/05/06-H-029   upgrade. In my case, I had to make the modification due to failure of pin diode D3. Clic here to see the df8oe modification Click here to see "The pin diode circuit designer' Handbook" The variant has been to connect a G6S-2 signal relay as a switch of the antenna signal, but taking care that capacitor C81 is earthed in TX mode. Else, in RX mode, the antenna is isolated from PA out. In this way, the shunt function of D4  pin diode is emulated. Protection by diodes 1N4148 -or similar- has always been discussed because the intermodulation effect that would cause an incoming strong signal exceeding 500 mV .Unlike df8oe, I used an NPN transistor to pilot the relay. Now switching transition between RX and TX is done the way that the RX band-pass is complet...

The P6 jumper, located near the MCU, allows you to write the bootloader for the first time (in a new MCU) or also to replace the bootloader when necessary. The problem is that jumper P6 is located on the inside face of the UI board. It is highly recommended to "extend" the jumper towards the edge of the UI board. In this case, I stuck a waste of a female connector with glue and made the male jumper by joining two pins of a male connector. In this way you can rewrite the bootloader without having to disarm almost completely the transceiver.